Visonic TOWER 20 AM - INSTALLER GUIDE Dokumentacja Pobierz pdf (Strona 3)

D-304046 TOWER-20 PG2 Installation Instructions 3

2.2 Battery Insertion

It is recommended to perform the first batteries insertion on a flat surface (see Figure 4). After battery insertion, the LED will flash for 60

seconds and then the detector will enter a 15 minutes' local diagnostic mode.

A. Tamper switch B. Press firmly to release the bracket C. 3 screws

Figure 4 – Battery Insertion

2.3. Enrollment

Refer to the PowerMaster control panel's Installer Guide and follow the procedure under the "02:ZONES/DEVICES" option of the Installer Menu.

A general description of the procedure is provided in the following flow chart.

Step 1 Step 2 Step 3 Step 4

Enter the Installer menu and select

“02:ZONES/DEVICES”

Select "ADD NEW DEVICE"

See Note 1

Enroll the device (see Figure 5) or

enter the device ID

Select a detector number for

the new flood detector







Step 5 Step 6 Step 7

Configure Location, Zone Type &

Chime parameters

Enter PARTITIONS.

See Note 2

Assign partitions to the detector by

pressing the

and/or

buttons on the

panel



 means scroll and select

Notes:

[1] If the detector is already enrolled you can configure the detector parameters and assign partitions via the “Modify Devices” option – see

Step 2.

[2] PARTITIONS will appear only if PARTITIONING was previously enabled in a panel that supports the Partitioning feature (for further details,

see "Partitioning" in the PowerMaster Installer Guide).

Z14.SET CHIME

Z14.ZONE TYPE

MODIFY DEVICES

Z14.LOCATION Z14.PARTITIONS Z14:P1 P2 P3

ID No. 130-XXXX

Z14:Motion Sens

ENTR ID:XXX-XXXX

ENROLL NOW or ADD NEW DEVICES

02:ZONES/DEVICES

1 2 3 4 5 6

Komentarze do niniejszej Instrukcji

Brak uwag

Visonic TOWER 20 AM - INSTALLER GUIDE Dokumentacja Strona 3

Komentarze do niniejszej Instrukcji