Visonic POWERMASTER-10 - INSTALLER GUIDE Dokumentacja Pobierz pdf (Strona 63)

6. PERIODIC TEST

62 D-303222 PowerMaster-10/30 G2 Installer's Guide

Option

Configuration Instructions

04:FOB/KP PANIC

Define the devices that cannot trigger a panic alarm.

DD243 – MCT-234.

all - All devices can trigger a panic alarm

05:CONFIRM ALARM

Define a specific time period that if 2 successive alarms occur, the second alarm will be

considered as a confirmed alarm, (see REPORT CNFRM ALARM below).

Options: 30/45/60 (default)/90 minutes

06:CONFIRM PANIC

A confirmed panic alarm is reported if one of the following occurs within the confirmation time:

a) A second panic device is activated.

b) A second panic alarm on the same device is activated.

c) A tamper event is activated (not from the zone / device that initiated the panic alarm).

Options: 4/8/12/20 (default)/24 hours and disabled

07:RPT CNFM ALRM

Define whether the system will report a confirmed alarm.

enable + bypass (default) - The system will report a confirmed alarm and will bypass all

alarmed open zones when the siren ends or when the confirmation timer expires.

disable - The system will not report a confirmed alarm.

enable - The system will report a confirmed alarm.

08:ENTRY DELAY 1

09:ENTRY DELAY 2

Two different entry delays allow the user to enter the protected site (while the system is in the

armed state) via 2 specific doors and routes without causing an alarm.

Following entry, the user must disarm the control panel before the entry delay expires. Slow-

rate warning beeps start sounding once the door is opened, until the last 10 seconds of the

delay, during which the beeping rate increases. Locations No. 1 (entry delay 1) and 2 (entry

delay 2) allow you to program the length of these delays.

Options: 10/15/30 (ENTRY DELAY 1 default)/45/60 (ENTRY DELAY 2 default) seconds;

3/4 minutes

6. PERIODIC TEST

6.1 General Guidance

This mode provides you with the means to conduct a periodic test, via the "PERIODIC TEST" menu, at least once a

week and after an alarm event.

When you are instructed to perform a periodic test, walk throughout the site to check the detectors / sensors (except for

Sirens and Temperature Sensors). When a detector/sensor is triggered into alarm, its name, number and the alarm

reception level should be indicated (for example, "Bathroom", "Z19 strong") and the buzzer should sound according to

the alarm reception level (1 of 3). Each device should be tested according to the device Installation Instructions.

To enter the "PERIODIC TEST" menu and to conduct a periodic test, proceed as follows:

Step 1



Step 2



READY

[1]

Select the test to be performed

[2]



PERIODIC TEST

(enter installer /

master code)

SIRENS TEST

TEMPERATURE TEST

TEST ALL DEVICES

TEST ONE DEVICE



– Periodic Test

[1]

Not including Siren and Temperature Sensors

[2]

After reviewing all untested devices the control panel will read "<OK> TO LEAVE". You can now do one of the

following: press to abort the testing procedure; press to continue the testing procedure; or press

to exit the testing procedure.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 81 82

Komentarze do niniejszej Instrukcji

Brak uwag

Visonic POWERMASTER-10 - INSTALLER GUIDE Dokumentacja Strona 63

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Visonic POWERMASTER-10 - INSTALLER GUIDE