Visonic POWERMASTER-10 Podręcznik Użytkownika Pobierz pdf (Strona 17)

OPERATING THE POWERMASTER SYSTEM

16 D-303223 PowerMaster-10 / PowerMaster-30 User's Guide

Initiating Emergency Alarm

You can generate a silent emergency alarm manually in the disarmed and armed states, as follows:

PRESS RESULTING DISPLAY

EMERGENCY

for 2 seconds

Then, if or when the

system is in the disarmed

READY HH:MM

(alternating)

READY MEMORY

Siren Alarms

The maximum operating time of the siren is configured by the installer according to local regulations.

Continuously ON when initiated by a burglar zone or a 24-hour zone, and when a user initiates a “panic alarm”.

When initiated by a fire zone (smoke is detected) ON - ON - ON - pause - ON - ON - ON - pause - ........ and so

on.

If there is nobody around to disarm the system upon alarm, the siren will sound for the time duration set by the

installer - then will stop. If enabled, the strobe light will keep flashing until the system is disarmed or the siren will

stop as configured by the installer.

Chime ON/OFF

You can disable / enable the chime zones (see Appendix B) by alternate clicking of the key, as shown

below:

PRESS RESULTING DISPLAY

CHIME ON

CHIME OFF

↓

READY HH:MM

CHIME indicator lights steadily when “chime on” is selected.

Adjusting the Volume of the Beeps

You can control the volume level of the sounded beeps by using the and keys on the keypad.

The following diagram shows how to increase the loudness of the beeps by clicking the <1> key (assuming that

the volume was at minimum to begin with).

PRESS RESULTING DISPLAY

VOLUME+

(max)

VOLUME+

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 75 76

Brak uwag

Visonic POWERMASTER-10 Podręcznik Użytkownika Strona 17